1. Daily Maintenance (Every Shift)
Before startup, manually rotate the pump shaft to ensure smooth operation without jamming. Remove debris from the inlet, verify the correct direction of rotation, and prime the pump with the conveying medium before starting. Never operate the pump dry.
During operation, listen for abnormal noises and check all connection points for leakage. Monitor conveying stability and keep an eye on the operating temperatures of the motor and gearbox.
After conveying corrosive, crystallizing, or sediment-prone materials, thoroughly flush the pump chamber, feed hopper, and associated pipelines. Remove all residual material to prevent crystallization, component jamming, or damage to the anti-corrosion lining. In cold weather, drain accumulated liquid to prevent freezing.
Check the gearbox lubricant level regularly and ensure it remains within the recommended range.
https://www.machinetailor.com/rock-wool-gypsum-equipment/anti-corrosion-screw-feeder-pump.html
2. Weekly Maintenance
Inspect all bolts and fasteners, tightening any loose connections. Check the condition of the flexible coupling elements and verify shaft alignment.
Apply suitable grease to designated lubrication points. Prevent corrosive materials from entering lubrication areas.
Remove accumulated material and dust from the equipment surface and motor cooling areas. Ensure that auxiliary sealing pipelines are clean and unobstructed.
For equipment that has been idle for an extended period, manually rotate the shaft and perform a brief jog test before restarting. Do not immediately operate under full load.
3. Monthly Maintenance
Inspect the rotor, stator, and anti-corrosion lining for wear, peeling, cracking, or corrosion.
Examine mechanical seals, sealing rings, and gaskets for aging, swelling, cracking, or damage. Sealing components tend to wear faster under corrosive operating conditions, so keep suitable spare parts available.
Check the wear and corrosion condition of the inlet lining plate. Inspect the gearbox oil for discoloration, contamination, or other abnormalities, and replace it when necessary.
4. Periodic Inspection and Lubrication
After the initial running-in period of a new pump, replace the gearbox oil. Subsequent oil changes should follow the manufacturer's recommended intervals and actual operating conditions. Always use the specified lubricant and never mix different oil types.
Replenish bearing grease or replace bearings according to the maintenance schedule and operating conditions.
Regularly test the dry-running protection, pressure protection, and other safety devices to ensure they function correctly.
Carry out periodic complete equipment inspections and overhauls. Check wear-prone components such as universal joints, rotors, stators, and mechanical seals. Replace worn parts and recalibrate shaft alignment when necessary.
5. Protection During Long-Term Shutdown
Thoroughly flush the pump and completely drain the conveying medium. Allow internal components to dry sufficiently. Apply suitable protective treatment to wetted anti-corrosion components using products that will not damage the protective lining.
Seal the inlet and outlet openings to prevent dust, debris, and foreign objects from entering the equipment.
Protect the motor and electrical components against moisture.
Manually rotate the pump shaft at regular intervals to prevent shaft deformation and prolonged compression deformation of the stator.


